Intune client preventing SCCM client push install

Apparently SCCM client and Intune client cannot co-exist. SCCM client push install will break when trying to run the "ccmsetup" service, with a cryptic messages like:


Failed to get client version for sending state messages. Error 0x8004100e ccmsetup 2/12/2015 9:46:40 AM 8780 (0x224C)
Params to send '5.0.8239.1001 Deployment Error: 0x87d00264, ' ccmsetup 2/12/2015 9:46:40 AM 8780 (0x224C)
Sending Fallback Status Point message to 'sccm.company.com', STATEID='328'. ccmsetup 2/12/2015 9:46:40 AM 8780 (0x224C)
ccmsetup 2/12/2015 9:46:40 AM 8780 (0x224C)
State message with TopicType 800 and TopicId {94BECBCB-8056-4BF4-B4E4-31E5E90BA2EB} has been sent to the FSP FSPStateMessage 2/12/2015 9:46:40 AM 8780 (0x224C)
CcmSetup failed with error code 0x80004005 ccmsetup 2/12/2015 9:46:40 AM 8780 (0x224C)

To uninstall Intune manually:

http://www.petervanderwoude.nl/post/uninstall-the-microsoft-intune-client/

You might have to manually push the SCCM client a couple of times before it will work. Also make sure that the client computer reboots before attempting SCCM client install again.

watchOS 2 - Two great features

There are two great new features in watchOS 2 that are not well known/mentioned:

1. When placed in Nightstand mode (by charging the Apple Watch), the screen comes on when it detects motion. Official documentation says that the watch is woken up by touching the screen or pressing either the crown or button, but I have found that the slightest motion would wake it up, so it's great when you are fumbling for the time in the middle of the night
2. The passcode screen has way way larger buttons for the number pad. When I had the 38mm model, it would always take me more than 2 tries. Even with the 42mm model and after a few months of having the watch, I would still consistently enter the wrong passcode. With watchOS 2, the number buttons are rectangle and the gaps between the buttons are way smaller, making it easier to hit the right number.

Resettiing Brother HL Laser Printer Low Toner Message

These steps will help you reset the low toner message:

1. Open front door
2. Turn off printer
3. While holding down the GO button, turn printer back on
4. When all four LEDs light up release GO button. All LEDs will turn off
5. Press the GO button 2 times. The 3 LEDs (toner, drum, paper) will light up solid
6. Press the GO button 5 times
7. Paper light will be blinking
8. At this point the toner end-of-life condition has been reset. Close front door.
*Also, just a reminder, timing is important here so don’t pause between button presses*

Source: http://supplies-outlet-blog.com/reset-the-low-toner-message/